TECHNICAL SPECIFICATION SHEET SKID- SAFE FLOOR
INDUSTRY 1.50MM & 2.00 MM LINING

• Visual Observation (mm) Should be free from pin holes, blisters, porosity & visual defects.
  Color Fastness To Day Light (%)IS: 2076 The Color Fastness correspond to at least standard No. 4
• Thickness(mm) Min Max. Mean
  The mean thickness shall not differ by more than 0.13 mm from that specified
  
  Variation in Thickness(mm)
  The variation between any two measurements shall not exceed 0.20 mm
  
  Width(mm)%
  Shall not be less then that specified and no t 6 mm more then that specified
  Heat Ageing And Exudation (At 700c For 15 Days) No exudation of plasticizer shall be apparent nor shall there be any change in appearance. The mandrel test shall no t produce surface cracking
• Residual Indentation (mm) Shall not exceed 0.10 mm
  Elastic Product ((mj/m3) The mean product of tensile strength and elongation shall be not less than 2MJ/m3.
• Flexibility (00c For 60 Minutes) Shall not break crack or show any other signs of failure
  Abrasion Resistance 0.35 cm3 as per IS:9532
• Ply Adhesion (kn/m) Adhesion between plies in any test piece shall not be less than 1.05 KN/m.
  Flammability ((mj/m3) 1Class B
• Dimensional Stability (%) Machine direction(mm)
  Change in any linear dimension
  
  Transverse direction (%)
  shall not exceed 0.40 percent.
  
  Visual Inspection (%)
  shall not exceed 0.40 percent.
  Moisture Movement (%) IMachine direction (%)
  Change in any linear dimensions shall not exceed 0.4 percent
  
  Transverse direction (%)
  Change in any linear dimensions shall not exceed 0.4 percent.
• Curling (mm) Shall not exceed 0.75 mm